520-HC 9 pin

[cafoose 3,760]

Does anyone know or any diagram available that shows the 9 pin on the 520 where each pin goes on the engine side? Looking for an actual picture of the pin showing the numbers so I can see which pin corresponds to which number on the actual connector. I have the demystification guide and wiring diagrams but they show the 9 pin in a straight line. @lynnmor @cleat @gwest_ca

Edited 11 hours ago by cafoose

[cafoose 3,760]

This correct?

 

9    6    3

8    5    2

7    4    1

[peter lena 9,940]

@cafoose  just curious , ever think about  changing that  hot wire  routing issue ?  favoring hot engine discharge  zone ?  drive belt  guard , venting , its always there , pete

[cafoose 3,760]

18 minutes ago, peter lena said:

@cafoose  just curious , ever think about  changing that  hot wire  routing issue ?  favoring hot engine discharge  zone ?  drive belt  guard , venting , its always there , pete

  Yes that's on the list just trying to determine where the wires go for my Vanguard swap.

 

 

 

[squonk 47,374]

I chopped that 9 pin right out of there. Used 2 4 flat trailer plug kits with long pigtails. Marked them "A" and "B" changed 1 wire at a time and documented what circuit when onto what pin in what connector. Move the whole thing to the other side of the tractor away from the heat. 

[sqrlgtr 3,243]

demystify.pdf there is a good diagram in here somewhere toward bottom of pdf... i cant get link to work maybe someone else can get for ya.. Its in the manuals section on here

Edited 9 hours ago by sqrlgtr

[sqrlgtr 3,243]

try this one

[cafoose 3,760]

6 hours ago, sqrlgtr said:

demystify.pdf there is a good diagram in here somewhere toward bottom of pdf... i cant get link to work maybe someone else can get for ya.. Its in the manuals section on here

Got it already