FarmallFarmer09 19 #1 Posted 4 hours ago Just picked up a fresh sheet of stickers for my charger 12. Whats the best way to apply them ive heard soapy water and squeegee it out or just stick em on there, what do yall recommend? Share this post Link to post Share on other sites
ri702bill 11,952 #2 Posted 2 hours ago If you bought them from Terry - @Vinylguy - why not ask him what he recommends..... Share this post Link to post Share on other sites
FarmallFarmer09 19 #3 Posted 2 hours ago Bought them from maple hunter decals Share this post Link to post Share on other sites
JCM 11,135 #4 Posted 1 hour ago Spray the CLEAN surface liberally with Non - Ammonia Windex . apply the decal and remove all the air bubbles from between surface and decal. Share this post Link to post Share on other sites
c-series don 11,859 #5 Posted 24 minutes ago DO NOT try to put them on without soapy water or using @JCM’s recommendations. A credit card works good to squeeze out the air bubbles and excess soapy water. Putting them on wet allows you to move the decal around to the exact spot you want it. Share this post Link to post Share on other sites
Bar Nuthin 2,347 #6 Posted 1 minute ago If they're going over a fresh paint job, it's important to sand any dust nibs out of the paint with some fine wet-sand paper (like 1000 grit). Share this post Link to post Share on other sites
