What have you done to your Wheel Horse today?

[kpinnc 17,287]

6 minutes ago, Handy Don said:

Cleaning

 

Yep, cleaning this time. Those white PVC fences change over to green here. Usually more in fall than other times it seems. 

 

But I also spray with the same setup with weed killer a little later. 

[MainelyWheelhorse 2,341]

 

Today, in this preview of spring/summer which was an uncommonly warm 70 degree day. I got the 308, 312 and C-141 out, wiped the dust off, and went for a short spin on the C-141. I also did some cleaning out, raking crushed rock out of the lawn, and organizing tractor parts. Now to wait for another week and a half roughly until spring is official. Tomorrow, it’s supposed to be rain and 30 degrees cooler.

[BrianKoch 355]

Gentlemen, 

 

Today I begin the process to repair my 42" side discharge mower deck for my '68 Charger 12 and could use some help from you all. The issue at hand is I cannot seem to keep the belt from slipping off the center pulley and I do not understand why. A few years back, I modified my Charger to run the deck from a mule drive and have ran the setup without a problem since. However, last season I needed to remove the center spindle assembly and chase the threads on it to better hold the blade retaining nut. Ever since that minor surgery, something is off and the belt slips every time. Based on my photo, does anyone see anything off with the geometry or anything else...(pic is of belt slipped off pulley for the umpteenth time). I'd like to try fixing before searching for another deck, but that's not off the table for me either if anyone has one. Thank you, Brian

 

 

Edited 4 hours ago by BrianKoch

[953 nut 64,315]

13 minutes ago, BrianKoch said:

Based on my photo,

Your photo wouldn't open for me. Post the photo itself rather than a link to it.