Teddy da Bear62 172 #1 Posted Sunday at 02:42 PM Title says it all. I want to confirm my spring and linkage. Unfortunately everything I run across doesn't have a "wheel horse" k532 view. There must have been dozens of configurations. Share this post Link to post Share on other sites
pfrederi 21,107 #2 Posted Sunday at 03:05 PM Didn't C-195 come with KT-19 motors??? 1 Share this post Link to post Share on other sites
8ntruck 9,262 #3 Posted Sunday at 10:08 PM C-195's came with KT-19 engines. I think @ebinmaine has a K532 on his Colossus project I rember correctly, the engine was originally on a welder. Share this post Link to post Share on other sites
ebinmaine 80,504 #4 Posted Sunday at 10:23 PM 7 hours ago, pfrederi said: Didn't C-195 come with KT-19 motors??? Yes. Hence the "19"... 7 hours ago, Teddy da Bear62 said: There must have been dozens of configurations. Certainly were differences over the years. My own was set up with a very short set of sticks & cables that barely reached the holders at the top of the engine. 10 minutes ago, 8ntruck said: C-195's came with KT-19 engines. I think @ebinmaine has a K532 on his Colossus project I rember correctly, the engine was originally on a welder. Close.... Mine is a K582 that was in a home shop made generator when I got it. I don't recall the year. I do remember that it's had yellow, dark blue, and OD green paint. The yellow could have been OE, the other two colors are close match to military but no history is known. Share this post Link to post Share on other sites
8ntruck 9,262 #5 Posted 39 minutes ago (edited) @Teddy da Bear62 I grabbed some pictures of the carb linkage on my C-195. The guy I bought it from said that he had replaced the carb, so I can't sayif it came from the factory this way. The throttle and governor work OK. The choke is not connected to the choke laver on the dash at the moment - seems the choke shaft on the carb is 90 degrees different than the original carb. Picture 1. Throttle cable connection to bell crank on left side of tractor. The link on the other end connects to the governor arm. Picture 2. Governor arm. Left-hand side spring goes to bellcrank that the throttle cable connects to. The link on the right hand of the governor arm connects to the throttle shaft. View is from the rear of the carb. Picture 3. The link between the governor arm and throttle shaft. Picture 4. Another view of governor arm to throttle shaft. This view also shows the choke shaft - it is horizontal on this carb, where on the original carb, the shaft ran vertically. Hope these help you. Edited 25 minutes ago by 8ntruck Share this post Link to post Share on other sites
