I would like to put a 23hp Kohler command in my C-85 how electronically could I wire it up to run off a key?

[MainelyWheelhorse 2,970]

So I’d like to put this, 

 

 

in this…

As far as I know the only thing it needs electronically to run the engine separately, is a key switch that at least by part number is the same as the Magnum’s. What else do I need electronically to be able to run it in my C-85? I assume I’d need a small rectifier like the Magnum’s as well, possibly a solenoid. At least this time I have a good idea what it needs but I’m completely new to the Commands. Thanks!

 

Edited 10 hours ago by MainelyWheelhorse

[953 nut 67,854]

Here ya go, all of your other wiring including safety switches will work just fine.

 

[953 nut 67,854]

46 minutes ago, MainelyWheelhorse said:

need electronically to be able to run it in my C-85? I assume I’d need a small rectifier like the Magnum’s as well, possibly a solenoid. At least this time I have a good idea what it needs but I’m completely new to the Commands

The solenoid is mounted on your starter and the voltage regulator / rectifier is the same as any magnum, it is probably already mounted near the flywheel fan.

[JCM 11,323]

That C-85 looks very familiar Justin. Engine looks nice in there. Good luck

[MainelyWheelhorse 2,970]

24 minutes ago, JCM said:

That C-85 looks very familiar Justin. Engine looks nice in there. Good luck

@JCM Thanks, I figured you might recognize it 😁.

[MainelyWheelhorse 2,970]

35 minutes ago, 953 nut said:

The solenoid is mounted on your starter and the voltage regulator / rectifier is the same as any magnum, it is probably already mounted near the flywheel fan.

Ok, I’ll give it a look. Once I saw the parts start coming back as also magnum parts I thought this might not be a C-141 level repower.