520-HC no compression

[cleat 9,005]

19 hours ago, cafoose said:

What's the best way to get the plastic knobs off the 520 choke and throttle levers?

 

Claw hammer, just pretend you are pulling a nail.

[sqrlgtr 3,237]

52 minutes ago, cleat said:

 

Claw hammer, just pretend you are pulling a nail.

I never had any trouble getting them off but have had to use a little glue to keep them on afterward.  Others may have a better solution to keeping them on, I hate to use super gliue on anything I think I might have remove again later on.

[cafoose 3,759]

Claw hammer works great 

[Handy Don 16,937]

2 hours ago, sqrlgtr said:

I hate to use super gliue on anything I think I might have remove again later on.

My go-to for these is a tiny dab of hot glue applied to the tip of the arm. 

[sqrlgtr 3,237]

1 minute ago, Handy Don said:

My go-to for these is a tiny dab of hot glue applied to the tip of the arm. 

This I will try if, I mean next time, I have to do another.

[kpinnc 18,740]

7 hours ago, cafoose said:

@kpinnc Is this the manifold you used?

 

No sir. The bend on that one is backwards from what I used. You want the shorter leg on the front and the hoop facing up. Otherwise it will interfere with the PTO engagement. 

 

You'll have to weld whichever end shut that is open and add an adapter closer to the middle to make it the way I did. I used a reducer from the auto parts store and flattened it to an oval on the manifold side.