Sunstrand Foot Control

[Racinbob 12,812]

I have posted an ad for a batch of hydro foot controls. I was just asked if they would work on a Sunstrand. As far as I know they are for Eatons only. Most of you know how the control rod hooks up to the shaft to operate an Eaton. Does anyone have a picture of where a Sunstrand would connect? Would it just take a different rod? Or 

[pfrederi 19,961]

Sundstrand motion control movement is vertical..Eaton movement is horizontal

[JoeM 9,647]

Seems as I remember someone having an external setup on a Sunny Strand. ???

[ebinmaine 77,544]

@Handy Don   ?

[oliver2-44 11,272]

Matts Foot Pedal was made for an Eaton

But he would sell it for a Sundstrand and he would buy (extra $$) some part off Ebay (maybe off an Eaton)

I'll  see if I can figure out what it was. 

Edited yesterday at 02:57 PM by oliver2-44

[midpack 1,108]

On 3/13/2026 at 9:52 AM, JoeM said:

Seems as I remember someone having an external setup on a Sunny Strand. ???

I made one with a clamp on the motion control rod and a pedal from a 269H along with a couple springs to get it to return on its own. Not pretty but it works really well. Its probably been close to a decade but it still goes fine.

[cafoose 3,635]

2 hours ago, midpack said:

I made one

I need to figure one out for a GT-14  I need it because of the FEL 

[oliver2-44 11,272]

Here,the standard parts in Matt’s Pedal Kit. 

 

For a Sundstrand he supplied this part to convert the motion control. 

Can someone confirm the vertical part is added on to a standard Eaton motion controller. 

 

[Handy Don 16,017]

On 3/13/2026 at 10:27 AM, ebinmaine said:

@Handy Don   ?

As you can see from @oliver2-44’s pictures, Matt’s kit took advantage of the existing rocker (Part #11 in this ’95 520-H IPL) by connecting his linkage in the same way that WH did with Part #52 from the column-mounted motion control lever. 

Parts 7-10 and 12-17 comprise the link between the #11 rocker and the Eaton motion control lever atop the transaxle. The rocker supplies “fore and aft” motion to the link. I haven’t seen details (either in person or on an IPL) of how the rocker translates control input motion to the vertical motion that the Sunstrands require. 

 

[pfrederi 19,961]

This is the sunstrand rocker.  I guess if you put a ball end pin in the back of the eaton rocker you could get the vertical motion you need.  I don't see it the picture oh Matts part above.  Also not sure the pivot points are in the same location.

 

 

[Bill D 2,608]

3 hours ago, oliver2-44 said:

Here,the standard parts in Matt’s Pedal Kit. 

 

For a Sundstrand he supplied this part to convert the motion control. 

Can someone confirm the vertical part is added on to a standard Eaton motion controller. 

 

That vertical part is standard.   There is a hole on the rear right corner where you can add a ball stud.

[pfrederi 19,961]

47 minutes ago, Bill D said:

That vertical part is standard.   There is a hole on the rear right corner where you can add a ball stud.

 Are you sure??? ....the ball stud has to come out of the rear of the rocker to hookup with the plastic slider....