Up Down Lift

[sqrlgtr 1,250]

Look what I found in mail today. New decal for HY2 lift lever on 1257. Cant wait to see what it looks like on tractor. How lucky are we to have a member like @Vinylguy as a member here?????  

[adsm08 3,826]

Those won't work for me. When I switch from the deck to the plow the up and down switch too.

[kpinnc 16,141]

6 hours ago, sqrlgtr said:

How lucky are we to have a member like @Vinylguy as a member here?????

 

Agreed 100% 

[Retired Wrencher 6,146]

5 hours ago, kpinnc said:

 

Agreed 100% 

I Second that. 

[squonk 44,853]

Terry did these custom decals for Marvin years ago.

 

 

[cleat 7,905]

7 hours ago, kpinnc said:

 

Agreed 100% 

I also agree.

My tractors would look naked without Terry's great decals.

 

[sqrlgtr 1,250]

Put decal on this morning 

[Handy Don 15,054]

19 hours ago, adsm08 said:

Those won't work for me. When I switch from the deck to the plow the up and down switch too.

Interesting. When implements are connected at their correct arms to the mid-tractor rock shaft on my 854 and on our 300 and 500 tractors the directions are consistent. If it was otherwise, lifting with the “arm strong” tractors wouldn’t work for all implements. 

How do your implements link to the rock shaft?

Edited 18 hours ago by Handy Don

[sqrlgtr 1,250]

Lift from mid-tractor rock shaft/bell crank. I

v

Haven't even paid any attention to the rear hitch it may be bass ackwards . I have since replaced thes olid lift link with chain for snow removal, but you get the idea. 

Edited 18 hours ago by sqrlgtr

[Handy Don 15,054]

1 hour ago, sqrlgtr said:

Haven't even paid any attention to the rear hitch it may be bass ackwards . I have since replaced thes olid lift link with chain for snow removal, but you get the idea. 

Yep, the forward-facing arm lifts mowers and the dozer and mid-blade.

The downward-facing arm lifts the blower (by pushing it at the bottom) and generator (similar to blower). It also lifts the rear attachment by pulling on the cable to the rear rockshaft. 

On “arm strong” tractors, pulling the lift lever rotates the rock shaft so that the two arms do their respective jobs. On hydros, the hydraulic cylinder does the pulling. 

Edited 16 hours ago by Handy Don

[adsm08 3,826]

3 hours ago, Handy Don said:

How do your implements link to the rock shaft?

 

Butterfly pins and nylock nuts mostly.

[wallfish 18,768]

 

23 hours ago, adsm08 said:

Those won't work for me. When I switch from the deck to the plow the up and down switch too.

 

59 minutes ago, adsm08 said:

 

Butterfly pins and nylock nuts mostly.

I believe Don was asking about how they are connected differently with the linkage or something in order to achieve the different lift directions of the hydro lever for those 2 different implements. Not so much what the hardware is.  Now I'm curious as well.