Got another one. A 416 this time.

[cleat 7,805]

Parking brake cam plate assembly ready to be installed.

 

Parking brake cam plate installed.

Pivot point was lightly greased.

 

[cleat 7,805]

Brake rod assembly ready to install.

 

Brake rod just inserted into parking brake cam and return spring installed.

Rod was greased where it inserts into cam plate.

 

Rod fully inserted into cam plate then washer and clip installed.

Note the smaller clip, the one shown earlier was causing interference with the cam plate bolt.

 

Brake return spring with rod fully installed into cam plate.

 

Brake spring and bolt assembly ready to install.

There should be 3 washers, only two are shown in this picture.

 

Brake spring assembly installed just finger tight.

I will set this later on when parking brake latch is installed.

 

Brake pedal ready to install.

 

Tractor ready to accept brake pedal.

 

Brake pedal installed.

 

Overview of complete brake system.

 

 

[cleat 7,805]

Hydro cam follower arm ready to install.

 

Hydro cam follower arm installed.

I put a tint bit of never seize on the male threads but kept the taper dry.

Nut tightened by hand (I was afraid an impact would over tighten and possibly crack the arm on the taper) while holding the arm so as not to break anything in the hydro unit.

 

 

[cleat 7,805]

Hydro speed control cam plate assembly ready to install.

This machine will have foot control so no tension washers are needed.

Instead, I punched out some Teflon washers so cam plate will pivot freely.

 

Hydro speed control cam plate spacers installed onto studs.

 

Hydro speed control cam plate lower washers installed.

 

Hydro speed control cam plate sat into place.

 

Hydro speed control cam plate bushing greased and ready to install.

I also put a little never seize on the studs.

 

Hydro speed control cam plate upper washers and bushing installed.

 

Hydro speed control cam plate locknuts installed.

Nut on bushing stud was firmly tightened.

Nut on washers was just turned in until there was little to no free play but the plate will pivot side to side freely.

 

Hydro speed control eccentric cam ready to be installed.

 

Hydro speed control eccentric cam installed and rotated so large side faces the long slot on the cam plate as per the manual.

Bolt tightened.

You will need a 1" and a 1/2" wrench to do this.

 

Tractor overview as of today.

 

Edited 6 hours ago by cleat