Jump to content

Recommended Posts

 

Should be located on the oil filter mounting flange.

 

Share this post


Link to post
Share on other sites
 

Just follow the black wire from your hour meter.

  • Thanks 1

Share this post


Link to post
Share on other sites
 

What engine do you have?? But 953Nut gave you the answer.

Share this post


Link to post
Share on other sites
 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Recently Browsing   0 members

    No registered users viewing this page.

  • Similar Content

    • By WVHillbilly520H
      @formariz, @PeacemakerJack, @Machineguy, @WHX21, @520hC-120, @dells68, @elcamino/wheelhorse, and the rest of ,       Here's some video (about 9:00 am this morning) of the Anniversary 520H and 2stage "chucker" in action from Diego that was only supposed to leave a trace to an inch ended up 9" in my front yard, Jeff.
      VIDEO0123.mp4 VIDEO0124.mp4 VIDEO0125.mp4 VIDEO0127.mp4 VIDEO0128.mp4 VIDEO0126.mp4
    • By Chuck14025
      Can anyone tell me how to get at the 9 pin connector under the battery platform on my 520H. I have pulled the battery out and the front plate off the dash (under the gauges) and the left side panel. Do I have to take the entire center of the tractor apart? 
    • By mmmmmdonuts
      I have a 1991 520h and I can mow for hours on end until I turn the tractor off and then restart it. The tractor restarts nice and easy warm but when I engage the PTO (mower deck) it slowly kills the engine. If I disengage the PTO it revs right back up. It is an electric clutch. I was thinking if it was a kill switch wrong I would imagine it would kill it a lot faster than allowing me to cycle on and off the PTO. Any thoughts? 
    • By Rich16
      Hi All,
      Looked on the site (and YouTube) and can't find anything comprehensive about adjusting valves without taking things apart - most are with engine removed I don't want to do.
      Can you adjust the valves with engine on by just taking off the air cleaner unit to expose the valve covers and take the plugs out?
      Can Top Dead Center be found without removing anything else or does the flywheel canopy have to be removed?
      I've adjusted valves on cars, etc and it's easy and straightforward - but I don't want to have to take anything apart that's unneccesary.
      Many thanks!
    • By The Tool Crib
      Hey y'all I have a 520 H which has some motor movement. Not sure if this is normal or needs to be tightened up. Any ideas? 
×