New to this! Help please

[nhs5023 10]

Hey guys, new to this and I just acquired a wheel horse that needs some work done to it. Runs and mows!!! Which is pretty awesome, but it needs some parts for the mower deck, wheels mainly, but I have no idea if parts are interchangeable, and no idea what model the traction unit is or deck size. All it says is wheel horse six speed. And on the engine it has...  K241.  Ser#  S C139023.       Spec. 46333 D     completely new to this and it may be dumb questions asked above but.... I'm lost. Any help with manual would be very much appreciated, or good places to order parts from would be awesome!!! I do have access to a toro distributor at work, and like I said, anything would be appreciated. 

 

Thanks in advance,

Nate. 

[Achto 29,408]

Sounds like you may have a 1067. Is the serial number / ID tag still on the tractor?  The Engine is a 10 horse. If it is a 1067 the tag would be below the dash. Pics may help us with ID too.

Edited August 14, 2016 by achto

[benji756 341]

to red square

[953 nut 60,160]

      Presuming that is the original engine you have a 1967 model 1067 , here is your manual.

 

@achto posted while I was attaching the manual, at least we agree! Six inch deck wheels and shoulder bolts should be at Ace, Lowe's or Tractor Supply.

[AMC RULES 37,196]

  

[nhs5023 10]

You're right with the tag below the dash T 1067. Thanks guys, that's awesome. Now when I'm looking for new wheels for the deck, are they all pretty much universal for wheel horses? 

Ps hope the picture uploads 

[Achto 29,408]

14 minutes ago, nhs5023 said:

Now when I'm looking for new wheels for the deck, are they all pretty much universal for wheel horses?

Should be able to find ones that will work at Tractor Supply, a hardware store or a garden tractor dealer. Take your old ones along for a reference.

[gwest_ca-(File Mod) 11,500]

May be this deck

If the part is priced here it should still be available from Toro. Often a part number will change over the years and a search for that will often yield other possibilities.

https://www.partstree.com/parts/

 

This site will often show other possibilities as well.

https://www.rcpw.com/

 

Garry

[roadapples 6,983]

   

[Ed Kennell 42,081]

Nice 1067 and deck.    to the        Where are you in Pa.?

[RedHorse54 578]

Yeah what ed said, where are you in PA? 

[KC9KAS 4,744]

[JC 1965 1,532]

[nhs5023 10]

20 hours ago, RedHorse54 said:

Yeah what ed said, where are you in PA? 

 

Othere side of the state there buddy. Lol near Pittsburgh. Thanks for all the replies guys! Any tips on deck removal? I got it off but I think it was an unconventional way... Had to remove the bolts off the deck and slide it out. Didn't take out the "R" pins and do it that way. 

[Ed Kennell 42,081]

Should only be 3 attachments;

1. the drive belt....loosen the tensioner on the right side and take the belt off the center deck pulley

2. the lift....un bolt the chain or bar from the center deck channel tab and secure it up out of the way

3. the mid attachamatic...pull the hairpin clip out on the left side, then push the lever forward opening the attachamatic and releasing the deck.

the deck should be free of the tractor, but you may have to jack up the front end to clear all the deck hardware when you slide it out.