medman 4 #1 Posted October 12, 2014 How do I release the trans to freewheel on a charger 10? I think it's a 1972 has 10 hp kohler on it I loosened this but didnt help(see pic) Share this post Link to post Share on other sites
rmaynard 16,291 #2 Posted October 12, 2014 (edited) It's a bad picture, but the valve is located here: Counter-clockwise 1/4 turn if I recall. Edited October 12, 2014 by rmaynard Share this post Link to post Share on other sites
daveoman1966 3,839 #3 Posted October 12, 2014 You are missing the valve...it should look like this on the top of the Hydrogear unit Share this post Link to post Share on other sites
medman 4 #4 Posted October 12, 2014 doesent have one of those in it just a plug Share this post Link to post Share on other sites
Callen 64 #5 Posted October 12, 2014 You have an early one.. it is on the back right under that splotch on the wire. 1/2 or 9/16 head,don't remember which, just loosen it a bit and just snug it when you're ready to run it. 1 Share this post Link to post Share on other sites
medman 4 #6 Posted October 12, 2014 (edited) You have an early one.. it is on the back right under that splotch on the wire. 1/2 or 9/16 head,don't remember which, just loosen it a bit and just snug it when you're ready to run it. worked perfect thanks again i see you race karts too Edited October 12, 2014 by medman 1 Share this post Link to post Share on other sites
Kegler 68 #7 Posted October 13, 2014 Reminds me of my first 'barn find' a '67 1077. PO had bought it new, also had a tiller with it. Anyway, when we went to roll it out of the barn it would not roll, so we pulled it out to where we could get it on my trailer. Not having much experience with WH I never thought about the Sunstrand parking brake! Pushed the handle down and rolled it right off the trailer. I now have 2 Sunstrand tranny's with working parking brakes. Share this post Link to post Share on other sites
