exchange a 700 tranny for a 1100 tranny ?

[fitter8 1]

i have a 516 ,runs great but i dont like the tranny ,want to put in a 1100 ,i understand that it will bolt right up to the rear end ,but could use some imput  on this ,will it screw up my controls? is there any thing else i should know thanks in advance ,fitter8

[squonk 39,132]

I think it's a direct swap but you would either have to install the hydraulic lift components also or loop the hoses. I'm not sure if there is anything else.

Edited September 16, 2013 by squonk

[Hodge71 663]

[Aussie 98]

The 1100 has an external filter bolted to the side of the fuel tank/seat base bracket. You would want to fit that as well.

[woodchuckfarmer 333]

I did this swap on a 518. I removed all the plugs and flushed out the inside with solvent. Then installed the filter assemble. Good luck its not to hard of a job.