Down pressure bar?????

[B-8074 19]

Went to the local Wheel Horse dealer to pick up a few parts. And I asked him about adding down pressure to my dozer blade. He said all I needed was a "Down Pressure Bar". I said ok, he said I'm out of them right now. They cost around $30 dollars. I said thanks. Anyway does anyone have one they could take a pic. of and get the measurements from it? He said I could make one but you have to get the angle right. Thanks in advance for the help.

[TT-(Moderator) 1,129]

There might be a few differences/variations, but the principal is the same.

From the RedSquare closet:

http://www.wheelhorseforum.com/index.php?showtopic=1187

[rickv1957 70]

Bar is 1-1/4" x 12" with pins on 10-1/2" center,Rick

[B-8074 19]

Thanks Rick.