how much play is trailer wheels is normal??

[truckin88 104]

I just repacked my trailer hubs and tightened the spindle nut hand tight and got the cotter pin in, tires track straight, when rotated, but I do notice about 1/8" of play on the hub, is this acceptable? it is the same on both sides.

[rmaynard 16,291]

I always tighten the nut until I can't turn the wheel. Then I back it off until the wheel turns free. I do this about 3 times. It makes certain that the bearings are fully seated. Cotter pin at closest hole. You should not have any noticeable play.

Bob

[VinsRJ 723]

I always tighten the nut until I can't turn the wheel. Then I back it off until the wheel turns free. I do this about 3 times. It makes certain that the bearings are fully seated. Cotter pin at closest hole. You should not have any noticeable play.

Bob

Agree totally.

[truckin88 104]

thanks have not driven it since replacing bearings and races, so I will take off the bearing buddies and do this, before I do, don't want to ruin the new bearings

[truckin88 104]

Did this worked great! Thanks

[Nick 13]

Didnt notice it mentioned but did you pack the bearings with some good wheel bearing grease ?

[truckin88 104]

Yes, I replaced all bearings and races, usewd mystik hi temp grease which lists wheel bearings as an application, plus put bearing buddies on.