Delkc01 1 #1 Posted November 13 Can anyone help me location where I maybe able to purchase a crankshaft, rod and piston assemblies for a K181S Kohler 8hp engine I need to rebuilt? Share this post Link to post Share on other sites
953 nut 70,439 #2 Posted November 13 The Spec number, 30108D is the most important information when looking for a crankshaft. We have a couple of venders here that you should start with. K&B Horse Parts @76c12091520h may have some NOS parts for the engine. A to Z https://a-ztractor.com/ will have used parts and may have NOS too. He sells on eBay but if you don't see what you are looking for give him a call. 2 1 Share this post Link to post Share on other sites
ri702bill 13,324 #3 Posted November 13 You WILL need to know the bore size before ordering a piston & a set of rings... Standard bore, .010 over, etc. If you plan to have the cylinder bored oversize, the Machine Shop needs those parts BEFORE they start... let THEM measure the bore to determine the correct size.... 3 Share this post Link to post Share on other sites
gwest_ca-(File Mod) 12,543 #4 Posted November 13 Here is an original parts list if you need it 2 Share this post Link to post Share on other sites
squonk 48,359 #5 Posted November 13 I have a crank. It may or may not need turning. You would need to get it checked. PM me if interested. 2 Share this post Link to post Share on other sites
Fordiesel69 274 #6 Posted November 13 If you need to, the k181 can go. 020 under. Often a machine shop can turn yours and then re fit the rod. So if your only needs to goto 11 or 16 thou they can custom bore your rod. I have 3 cranks. All need turned WAY MORE. 1 Share this post Link to post Share on other sites
oliver2-44 11,833 #7 Posted November 14 Before you buy parts, have you taken the block and crank to a show that machines small engines. Buying a used rank in good usable condition is probable a challenge. A shop may be able to grind you crank for less that buying one. 1 1 Share this post Link to post Share on other sites
Delkc01 1 #8 Posted November 15 WOW....Thank you all very much for your replies and help here. Sounds like the best option to start with is grinding down my crank, so I am going to start there and fingers crossed this repair my overall issue. I will keep you all updated, and THANK YOU all again for your help here. Share this post Link to post Share on other sites
Delkc01 1 #9 Posted 5 hours ago Hi again all - Where would you recommend I find/purchase the following for the same engine? Standard size piston and ring set with new wrist pin and keepers Complete gasket kit with crankshaft bearings Share this post Link to post Share on other sites
pfrederi 21,317 #10 Posted 59 minutes ago If your machine shop has measured your block and says STD then I have used lilredbarn.net also on ebay Share this post Link to post Share on other sites