Clevis hitch and rockshaft diy- my version

[Stan50 223]

Last few days was very productive, I made clevis hitch along with rockshaft and other small pieces. I can't take credit of this version completely because I found many ideas on this forum .

Unfortunately clevis hitch is not perfect, my tools are basic and  mechanical skills too, but everything works well. I don't have any hitch attachements but that will probably change. I think about some kind of rakes and weeder/ cultivator. I don't need plow or tiller.

Clevis hitch is slightly bigger, measurements are little bit different (slightly longer and wider at trans shaft) - I adjusted it to my homemade receiver hitch. Receiver hitch had to be improved too. 

 

 

 

Shaft is not moving (7/8- 22 mm diameter),secured to side plate by nut, washers and spring cotter pin. Other spring cotter pins secure moving arm at one side and shaft itself. That arm is moving freely

Edited 2 hours ago by Stan50