Jason X 21 #1 Posted 14 hours ago My 72 Raider 8-10 was shifting harder and harder and now only finds reverse. I don't know much about these gear boxes. Not much about transmissions in general. Where do I start? Gear oil is fresh 80/90. Shifter? Forks? Anything would be useful. Thanks 1 Share this post Link to post Share on other sites
953 nut 68,722 #2 Posted 13 hours ago Check out this thredad. 3 Share this post Link to post Share on other sites
ri702bill 12,890 #3 Posted 5 hours ago (edited) Does it go cleanly into all the gears with the engine off? If so, your problem most likely stems from the drive belt not being stopped with the clutch pedal fully depressed. Easy enough to see (at least on a C series) - while off the tractor, start it in neutral, depressing the clutch fully by hand. Look across the battery area to find the drive belt - it should be stopped. If not, try adjusting the pedal back towards you for more throw. The belt guard MUST be installed, and correctly, for proper belt control. Most guards have tabs inside to aid in stopping the belt.... Edited 3 hours ago by ri702bill 1 3 Share this post Link to post Share on other sites
