Fabricating a Mid Mount Grader Blade Assembly for a D-Series Tractor

[BradKahler 397]

I've decided I need a mid mount grader blade for my 18 HP Automatic and I realize the odds of finding one are pretty much non existent so I'm going to make one.  I found someone that's willing to provide me with dimensions so I've started the ball rolling.  It took a few weeks but the fab shop was able to roll 1/4" steel plate so I now have the blade, the blade backing plate and some 1-1/2" x 2-1/2" tubing.  I'll post pictures and build information for anyone that wants to fabricate their own setup.  The two round discs are for fabrication of a rear hub puller for the 18 HP.  

 

More to come....

 

[TonyToro Jr. 2,523]

I’ll definitely be following along. Maybe my d series will need one.. 

[C100guy94 125]

Oh yea definitely following this. 

Would love to do this myself. 

If you don't mind me asking whats a shop charge to have that rolled? 

 

 

[BradKahler 397]

6 hours ago, C100guy94 said:

Oh yea definitely following this. 

Would love to do this myself. 

If you don't mind me asking whats a shop charge to have that rolled? 

 

 

 

I bought three items from the shop and didn't get a breakdown on cost.  I bought six feet of 1-1/2" x 2-1/2" tubing and online pricing puts the cost for that piece at about $80.  The total bill was $280 so that leaves about $200 to roll the two 1/4" thick plates.  I doubt the labor to roll two pieces, one long and one short, would be different for either piece since they are being rolled to the same curve.  I guess the bottom line is I would say I got the two rolled plates for $200 for material and labor.  

 

The grader blade I made for my B100 used 3/16" plate and was 48" wide and it only cost me about $60 for the blade and I'm guessing the difference in plate thickness probably had something to do with the price increase.

 

In the near future I'll upload the first drawing that shows some of the dimensions.  The guy I'm working with got most of them but there were a few missing and I need those dimensions to know what other materials I need to obtain.  

 

I'm in the middle of tearing into the transaxle at the moment so as mentioned previously, the grader blade project will stretch out over several months.  No need for a grader blade when the tractor isn't running

 

 

[C100guy94 125]

34 minutes ago, BradKahler said:

  No need for a grader blade when the tractor isn't running

 

 

Well logically you may be right there can't say I can argue. 

What I will say is the 😈 on my shoulder would probably be knocking out the 😇 on my shoulder telling me how I just have to do the blade first. 

 

But no your 100% right on what your doing just poking fun. 

You did an amazing job on the last blade.

And I would also much rather take the route your going. 

Spend the money at a shop to prep the blade then even finding a good conditioned one for the same cost or near. 

The experience also is something you don't get from buying used