JOEPOE1977 0 #1 Posted 18 hours ago (edited) I have a 1990 Wheel Horse 310-8. It has a 42 inch recycler deck. The deck has the original spindles on it and the Kohler MC10 has the original PTO clutch on it. I am continuing to burn and break belts on this unit. New blades on the deck which I just bought for a member on the sight. The last belt lasted me less than 3 hours. Any help very much appreciated on this. Thank you as always. Edited 18 hours ago by JOEPOE1977 Share this post Link to post Share on other sites
ri702bill 12,401 #2 Posted 17 hours ago Joe - Welcome!! Which belt is the problem one? The drive belt from the PTO or the belt that drives the 3 spindles?? Either case, it sounds like it is an alignment or bad bearing issue... Share this post Link to post Share on other sites
Ed Kennell 46,473 #3 Posted 16 hours ago to the Joe. Pictures of the pulleys involved may help us see the problem. Share this post Link to post Share on other sites
rjg854 13,156 #4 Posted 16 hours ago Yes pictures would be a big plus. 1 Share this post Link to post Share on other sites
953 nut 67,249 #5 Posted 4 hours ago Check out the mule drive pullies. Be sure they spin freely and are on the drive correctly. If you remove the nut (takes a 1 1/8" wrench or socket) you can check the order of the pullies. Between the guard and the flat pulley there is a spacer and another spacer between the two pullies. The shorter of the two spacers needs to be between the two pullies and the long one between the guard and the flat pulley. 1 Share this post Link to post Share on other sites
