Joshyg 32 #1 Posted 2 hours ago Model-6-6211 Serial-524241 Share this post Link to post Share on other sites
squonk 46,572 #2 Posted 2 hours ago That snowbblower is for the older models with out the front tach o matic Share this post Link to post Share on other sites
Joshyg 32 #3 Posted 2 hours ago Is there anyway I could modify this to fit my front tach o matic Share this post Link to post Share on other sites
Ed Kennell 46,078 #4 Posted 2 hours ago 1 minute ago, squonk said: That snowbblower is for the older models with out the front tach o matic It does have the frame mount attachment Mike. But I think the later C models have the two holes in the frame to use this mount. It should work. 1 Share this post Link to post Share on other sites
Handy Don 16,612 #5 Posted 1 hour ago 18 minutes ago, Joshyg said: Is there anyway I could modify this to fit my front tach o matic Almost anything is possible. Effort and compromises govern practicality. This model, per the interchange chart, was for 1968 and 1969 models that did not have Attach-a-Matic, had short or medium length frames, and may have had the pedal-activated PTO. It also could be used on some earlier 60’s models that used the earlier ST-326 Snow Thrower Factors: - holes in the frame rails to put the mounting bolt through and blower frame fitting around the front attach-a-matic - hood attachment and size for possible interference - PTO style and belt alignment/length - length and fit of lift tube 1 Share this post Link to post Share on other sites
Joshyg 32 #6 Posted 1 hour ago Got the snowblower on and the snowblower works fine with my tractor, but is there anything to lift it so I can lift the entire snowblower up? Share this post Link to post Share on other sites
Handy Don 16,612 #7 Posted 1 hour ago (edited) 23 minutes ago, Joshyg said: Got the snowblower on and the snowblower works fine with my tractor, but is there anything to lift it so I can lift the entire snowblower up? Nice going! Uss the search bar at the top of this page to look in documents or files on this site for “6-2211” or “ST-323”. Look for an IPL (illustrated parts list) and/or an OM (owner’s manual) among the files available. That will include the tube that connects the mid-tractor rock shaft arm to the bottom rear of the blower to lift it. You’ll likely need to fabricate one (or modify an existing one) since you have the thrower on a tractor it wasn’t designed for. Edited 1 hour ago by Handy Don Share this post Link to post Share on other sites
Ed Kennell 46,078 #8 Posted 1 hour ago (edited) I had that same blower on a C-120 and the "Flag and lift rod" worked with a few spacrs. Look around the POs barn. The flag and lift rods are usually standing in a corner. Edited 1 hour ago by Ed Kennell 1 Share this post Link to post Share on other sites
Joshyg 32 #9 Posted 46 minutes ago Is the one on the right a flag and lift rodI Share this post Link to post Share on other sites
