Duddy 0 #1 Posted 4 hours ago (edited) I try engage my mower beck and the clutch sometimes engage and sometimes not. When it engages if will go for a few seconds and then stop not sure whats the problem. Has anyone else had this problem and can help Edited 4 hours ago by Duddy Want to be notified on comments Share this post Link to post Share on other sites
gwest_ca-(File Mod) 12,220 #2 Posted 4 hours ago What year and model of tractor is this? Share this post Link to post Share on other sites
lynnmor 8,794 #3 Posted 4 hours ago What stops in a few seconds? Does the engine shut off? Share this post Link to post Share on other sites
Duddy 0 #4 Posted 3 hours ago The clutch and the mower deck Share this post Link to post Share on other sites
Duddy 0 #5 Posted 3 hours ago The engine stay running Share this post Link to post Share on other sites
lynnmor 8,794 #7 Posted 3 hours ago Looks like the belt isn't installed correctly on the mule drive, perhaps some photos close to that area might help. Share this post Link to post Share on other sites
wallfish 19,917 #9 Posted 2 hours ago Try this Remove the pin Drop down the rod tighten the trunion towards the seat a few turns Re-install and try it The lever should hold somewhat stiff once cantilevered over 1 Share this post Link to post Share on other sites
Duddy 0 #10 Posted 2 hours ago I have twisted it back as far as i can into the triangle piece to engage the clutch. And it still stops Share this post Link to post Share on other sites
