sqrlgtr 2,623 #26 Posted 20 hours ago 3 hours ago, 702854boy said: K321's are a 14, the 12 horses are k301s Went back and edited my post thanks for pointing that out wouldn't want to lead someone a stray. 1 1 Share this post Link to post Share on other sites
ineedanother 2,069 #27 Posted 17 hours ago I have (4) K341 that are all in use and plan to do this as time permits. I had an old k241 sitting here that needs rings and figured I'd just open it up and knock those out since I've never done it before. Well, they were already gone! I guess I'll do that lesson later. 1 Share this post Link to post Share on other sites
pfrederi 20,305 #28 Posted 17 hours ago What was the spec number of your K241? Share this post Link to post Share on other sites
ineedanother 2,069 #29 Posted 17 hours ago 9 minutes ago, pfrederi said: What was the spec number of your K241? 46636d Share this post Link to post Share on other sites
ineedanother 2,069 #30 Posted 17 hours ago 7 minutes ago, ineedanother said: 46636d K301 block as I think many were. Share this post Link to post Share on other sites
ineedanother 2,069 #31 Posted 17 hours ago 2 minutes ago, ineedanother said: K301 block as I think many were. 13 fins and I suspect a thicker cylinder wall than others, similar to some of the k341 but I'm not sure about any of that, truth be told... Share this post Link to post Share on other sites
Retired Wrencher 6,585 #32 Posted 8 hours ago 8 hours ago, pfrederi said: What was the spec number of your K241? I believe this is it. I can double check today. IMG_1089.mov Share this post Link to post Share on other sites
pfrederi 20,305 #33 Posted 6 hours ago There are no balance gears in that engine. 46333 Share this post Link to post Share on other sites
pfrederi 20,305 #34 Posted 6 hours ago 10 hours ago, ineedanother said: 46636d No balance gears in that spec number either. There are many variations of crankshaft for K241 engine only 5 of them had balance gears. Very uncommon to have them. Share this post Link to post Share on other sites
