Goldnboy 1,095 #1 Posted 4 hours ago I know a lot of members here run V61's on there tractors but I don't recall anyone mentioning that the mule drive can interfere with turning. I couldn't turn left fully without rubbing on te mule drive. So i added a 1/2" collar on the spindle two machine washers and then inserted a bushing inside the rim along with a longer bolt and problem solved. However for those running newer machines that use a snap ring in place of a bolt this would not be a viable solution. 1 1 Share this post Link to post Share on other sites
8ntruck 8,728 #2 Posted 1 hour ago They fit without any issue on my C-195. Then again, that is a completely different animal mule drive wise. Share this post Link to post Share on other sites
sqrlgtr 2,459 #3 Posted 1 hour ago 2 hours ago, Goldnboy said: I know a lot of members here run V61's on there tractors but I don't recall anyone mentioning that the mule drive can interfere with turning. What Mochine are you running those on? I put a set on a C160 but I havent had a mule drive on since mounting the V61's. Share this post Link to post Share on other sites
Goldnboy 1,095 #4 Posted 1 hour ago These are the original wide rims on a C120 8 speed. 1 Share this post Link to post Share on other sites
sqrlgtr 2,459 #5 Posted 11 minutes ago 1 hour ago, Goldnboy said: These are the original wide rims on a C120 8 speed. Well, I assume I would have clearance problems with the C160 also. I don't foresee using a mule drive on this tractor but was always nice to have options. Share this post Link to post Share on other sites
