ri702bill 11,653 #1 Posted yesterday at 02:07 PM Before reinstalling the large flange bushings for the C series Lift Lever, I decided to add a shallow grease groove centered in the ID. (@peter lena would approve) The 60 degree internal threading tool works perfectly for this. Judging by the fine powdery chips prodiced, these bushings are made of iron.... I did not expect that. 3 Share this post Link to post Share on other sites
702854boy 627 #2 Posted yesterday at 02:11 PM Your title is made up of the four most expensive words in the whole English language 9 Share this post Link to post Share on other sites
ri702bill 11,653 #3 Posted yesterday at 02:13 PM (edited) 2 minutes ago, 702854boy said: Your title is made up of the four most expensive words in the whole English language I see your point - it often requires a detour, but seldom to a deadend road.... Those bushings and the lack of them at all where the clutch goes thru the frame are almost impossible to lubricate under normal use except with a hit-or-miss spray wand. So.... Edited yesterday at 02:15 PM by ri702bill 1 3 Share this post Link to post Share on other sites
ebinmaine 78,063 #4 Posted yesterday at 02:32 PM Another excellent maintenance addition. 2 Share this post Link to post Share on other sites
ri702bill 11,653 #5 Posted yesterday at 02:57 PM 23 minutes ago, ebinmaine said: Another excellent maintenance addition. Even if this were done in place using a Dremel (and both the good eye & steadiest hand), it is still an improvement.... 3 Share this post Link to post Share on other sites
ri702bill 11,653 #6 Posted 6 hours ago On 4/13/2026 at 10:11 AM, 702854boy said: Your title is made up of the four most expensive words in the whole English language Right up there with "Yes Sir, I do".... 1 3 Share this post Link to post Share on other sites
