Dan 312-8 429 #1 Posted yesterday at 05:35 PM While walking the floor at the Classic Tractor Show today at the Lebanon, PA Expo Center, I spied this in a vendor’s booth. It’s advertised as a Wheel Horse Rear Tongue Weight, no ID tag on it. It’s designed to slide over the factory hitch, bolt through existing hitch pin hole and the weight provides a new hitch pin hole. Any of you out there ever see such an animal? OEM or homecrafted? Guy is asking $150 for it. I’m going back in the morning. I’d appreciate your thoughts and/or comments, Bests, Dan Share this post Link to post Share on other sites
SylvanLakeWH 30,546 #2 Posted yesterday at 05:47 PM Looks homemade... 5 Share this post Link to post Share on other sites
ebinmaine 77,220 #3 Posted 23 hours ago 46 minutes ago, SylvanLakeWH said: Looks homemade... Agreed. Likely would have been red if factory. Me personally... A. They're asking WWAAYYY to much. IMHO that's a $50 piece. NOT 3 times that. B. It's pretty close to useless because that weight greatly reduces the amount you can pull. Meh...... 2 Share this post Link to post Share on other sites
Chaz54 99 #4 Posted 23 hours ago IMHO… It looks too well made for homemade. But my guess is that it was a rear weight for an implement (non-Wheel Horse, hence the black paing) that would mount on the front of the tractor. 2 Share this post Link to post Share on other sites
Dan 312-8 429 #5 Posted 20 hours ago @SylvanLakeWH, @ebinmaine, @Chaz54, thanks for your insight. Eric, $50 was exactly what I thought. That is if you can pry that Grant out of my grasp. I’ll be leaving it lay where it’s at. Share this post Link to post Share on other sites
