Dan 312-8 463 #1 Posted February 20 While walking the floor at the Classic Tractor Show today at the Lebanon, PA Expo Center, I spied this in a vendor’s booth. It’s advertised as a Wheel Horse Rear Tongue Weight, no ID tag on it. It’s designed to slide over the factory hitch, bolt through existing hitch pin hole and the weight provides a new hitch pin hole. Any of you out there ever see such an animal? OEM or homecrafted? Guy is asking $150 for it. I’m going back in the morning. I’d appreciate your thoughts and/or comments, Bests, Dan Share this post Link to post Share on other sites
SylvanLakeWH 30,684 #2 Posted February 20 Looks homemade... 5 Share this post Link to post Share on other sites
ebinmaine 77,585 #3 Posted February 20 46 minutes ago, SylvanLakeWH said: Looks homemade... Agreed. Likely would have been red if factory. Me personally... A. They're asking WWAAYYY to much. IMHO that's a $50 piece. NOT 3 times that. B. It's pretty close to useless because that weight greatly reduces the amount you can pull. Meh...... 2 Share this post Link to post Share on other sites
Chaz54 99 #4 Posted February 20 IMHO… It looks too well made for homemade. But my guess is that it was a rear weight for an implement (non-Wheel Horse, hence the black paing) that would mount on the front of the tractor. 2 Share this post Link to post Share on other sites
Dan 312-8 463 #5 Posted February 21 @SylvanLakeWH, @ebinmaine, @Chaz54, thanks for your insight. Eric, $50 was exactly what I thought. That is if you can pry that Grant out of my grasp. I’ll be leaving it lay where it’s at. Share this post Link to post Share on other sites
wallfish 19,407 #6 Posted February 21 Well, that block of steel on it's own would cost more than $50. That being said, I don't think it's a $150 item but probably somewhere in the middle. It would make a better front weight IMO https://www.ebay.com/sch/i.html Share this post Link to post Share on other sites
