Domenic 11 #1 Posted 20 hours ago I split the case on my c175 because it started knocking and when I took the crank shaft out I noticed that the bolts holding the connecting rod onto the crank shaft were both lose. Ive been looking to buy a new piston rod and rod cap but cant seem to find one anywhere. If anyone knows where I can get one please let me know. Share this post Link to post Share on other sites
Achto 30,207 #2 Posted 18 hours ago (edited) 1 hour ago, Domenic said: Ive been looking to buy a new piston rod and rod cap but cant seem to find one anywhere Found some complete rebuild kits. https://www.ebay.com/itm/185525360554 Edited 18 hours ago by Achto 1 Share this post Link to post Share on other sites
pfrederi 19,278 #3 Posted 6 hours ago Parts are getting hard to find for KTs. Especially over/under. Pats small engine seem to have rods Share this post Link to post Share on other sites
953 nut 63,067 #4 Posted 6 hours ago You should have the cylinder jugs and crank measured at a machine shop to see what needs to be done before buying any parts. No need to spend a lot of money on rods, rings and gaskets only to find out that the engine has other problems. 1 1 Share this post Link to post Share on other sites
Blasterdad 3,094 #5 Posted 5 hours ago A little far away from you but... Share this post Link to post Share on other sites
