What have you done "WITH" your Wheel Horse

[CRF857 319]

On 7/1/2026 at 5:17 PM, MainelyWheelhorse said:

 

I've had good luck covering holes in seats with patches to fix leather couches. I found a roll of the material in various colors on Amazon for not much if I remember right. 

 

On 7/1/2026 at 6:23 PM, SylvanLakeWH said:

Gorilla tape will fix that right up and boy does it last... right color too... 

Thanks for the suggestions.

Amazon did a “free” overnight delivery. Got here a few minutes ago.

I will still tape it ,but like the cover and its pockets.

[MainelyWheelhorse 2,756]

@Brockport Bill Well, I need to come up with something different. I caught it on something mowing the fire station lawn and almost ripped it off. I think if I stiffen it around the holes, it would last longer as that was the only spot with issues.

[MainelyWheelhorse 2,756]

On 7/2/2026 at 6:58 AM, c-series don said:

I can’t tell you how many times that has happened to me. I look at a tractor I haven’t used in a while and think I should sell it. Then I use it for whatever reason and think no, I like this tractor, I don’t want to sell it!! 

Same here, I’m running out of room but then I grade the driveway with my plow tractor or take a ride on the C-141 I built and think nah I’ll figure something out to use this for.

Edited 4 hours ago by MainelyWheelhorse

[c-series don 12,023]

@MainelyWheelhorse How about if you sandwiched that piece with a piece of 1”x1”x1/8” angle iron? Not flat stock, angle iron with give it much greater strength. 

[EthanL 20]

Hauling water out of the creek to water the garden. A pump set up would be nice but I haven’t gotten there yet

[EthanL 20]

[MainelyWheelhorse 2,756]

3 hours ago, c-series don said:

@MainelyWheelhorse How about if you sandwiched that piece with a piece of 1”x1”x1/8” angle iron? Not flat stock, angle iron with give it much greater strength. 

@c-series don That’s what I was thinking too. It only ripped out around the holes.