Chrishar 785 #26 Posted September 10 (edited) Yay findly got my transmission parts in and a good starter cup too so this weekend I'm going to findly have time to work on it again because I only have 2 1/2 weeks to get it done for the big show in TX Edited September 10 by Chrishar Share this post Link to post Share on other sites
Chrishar 785 #27 Posted September 14 (edited) Well I thought I was going to have the transmission together today but I got the wrong four bearing shipped to me just sucks waited almost a month for them so I started taking the frame apart found some welds broken so tomorrow will weld them and fix the hood stand too Edited September 14 by Chrishar Share this post Link to post Share on other sites
Chrishar 785 #28 Posted September 15 Did some welding today fix the braces, new spring holder and fix the hole in the front bracket for the blade assembly 2 Share this post Link to post Share on other sites
Chrishar 785 #29 Posted Friday at 04:25 AM Transmission together with the help of Oliver2-44 with four good bearings until they get the new bearings figured out for me Share this post Link to post Share on other sites
Chrishar 785 #30 Posted Friday at 04:33 AM Transmission is on and will have new tires on the front tomorrow now just going through the parts and see what else have to fix and put on the suburban and get this thing up and going for the show in about two weeks 5 Share this post Link to post Share on other sites
wallfish 18,466 #31 Posted Friday at 11:23 AM You can change those bushings out and use wheel bearings instead. Bushings wear the spindles down so you might want to check those too. Probably not the most important thing on such a time crunch job 2 1 Share this post Link to post Share on other sites
Chrishar 785 #32 Posted Saturday at 07:19 AM How do you get the pulley off this stud Share this post Link to post Share on other sites
Chrishar 785 #33 Posted Saturday at 07:26 AM Some done today 4 Share this post Link to post Share on other sites
953 nut 61,081 #34 Posted Saturday at 12:07 PM 4 hours ago, Chrishar said: How do you get the pulley off this stud A Bearing Splitter will do the job you may be able to borrow on from an auto parts store. Share this post Link to post Share on other sites
Chrishar 785 #35 Posted Sunday at 03:52 AM Motor together and ready 3 Share this post Link to post Share on other sites
Chrishar 785 #36 Posted Sunday at 07:03 AM Motor, fenders, belt and belt guard on 5 Share this post Link to post Share on other sites
Chrishar 785 #37 Posted yesterday at 05:40 AM Little more done starting to look like something exhaust, seat and rear lift system done 3 Share this post Link to post Share on other sites
Chrishar 785 #38 Posted 9 hours ago Hood on and gas tank is ready to be put on that's tomorrow nights deal does anybody have a picture of how they ran the fuel line and the throttle and choke cables to the motor 1 Share this post Link to post Share on other sites
wallfish 18,466 #39 Posted 3 hours ago Fuel line, sediment bowl outlet directly to the carb. That line is short and just suspends. Not a bad idea to put a fuel filter in there too The choke is just a direct link wire from the lever to the carb. no conduit Throttle cable loops from the lever towards the hood stand and goes to the carb from the bottom 1 Share this post Link to post Share on other sites
