PTO clutch support screw torque

[cJ_3D 9]

Hey all!

 

Replacing the drive belt on my 252-h. Anyone know the torque specification for the center screw when I put this pto clutch back on? I know it was on there tight it took a minute for the impact to break it loose. Thanks!

 

CJ

[WHX?? 57,752]

I would go to the torque limit that bolt can carry. Guessing 80-90 ft lbs but consult a chart. 

[cJ_3D 9]

29 minutes ago, WHX?? said:

I would go to the torque limit that bolt can carry. Guessing 80-90 ft lbs but consult a chart. 

Hi WHX! Where can I find said chart? I've looked and can't find one. 

 

Thanks for the help!

[WHX?? 57,752]

Just  bolt torque chart. You'll find scads of them.

A good one will have all sizes, fine and coarse thread & most common grades... even metric. 

A must have in the shop for unspecified torque values. 

[cJ_3D 9]

3 minutes ago, WHX?? said:

Just  bolt torque chart. You'll find scads of them.

A good one will have all sizes, fine and coarse thread & most common grades... even metric. 

A must have in the shop for unspecified torque values. 

I'll give it a shot! Thank you!