Search the Community
Showing results for tags 'problems'.
Found 2 results
Hello , We have acquired a Wheel Horse Model 1-0394 It has been standing outside for about 10 years , the gearbox was full of water . We have cleaned the gears but the bearings were all shot . I understand the sxle ball race are not available so I have replaced them with a phosphor bronze bush which I think will be OK . The problem now is how to replace the spring loaded ball bearings holding the selectors . The first one is easy but how to hold the second ball down while sliding the plunger shaft in , Has any one done this ???? Regards Phil
I have a kohler 12hp engine in a 312A that's having issues. It will run with the choke on and throttle all the way up. If the choke is turned off it will die. After it warms up it will run without the choke on but only at the lowest throttle setting. Any suggestions? Thanks