Search the Community
Showing results for tags 'carburator'.
Found 2 results
-
just wondering if anyone knows which way the governer is supposed to turn when setting it. its a 1984 gt 1100 workhorse/ wheel horse? it has a horizontal 11 horse b&s 399cc.I'd rather not have to drain the oil again and open the engine up. just trying to get it running smooth and then maybe restore it. its in good shape. i may have put in more work than needed. its ran before not very long and i recently tried firing it up and was screamin at 5000rpm i would assume.
-
Working on a 1969 Raider 12 for a friend. As far as I can tell, the engine is the correct one for this tractor. It was missing the entire air cleaner, so the owner got an air cleaner housing, but I have found that it will not fit on this carb. The mounting holes on the air cleaner base are 1 7/8" center to center for both the horizontal and vertical holes. The carb has been roughed up a little and the 2 horizontal holes have been "wallowed" out and a piece of the aluminum casting has actually been broke off and some type of plastic filler was used to "hide" the damage. Can't do much to repair this as the choke shaft rotates here. The vertical holes on the carb are 1 5/8" center to center. Can anyone shed any light on this? Is the carb for older K301 engine different than the carbs for say a middle 70's K301? I think I will just pull this carb and install one off of another 12 hp that already has the air cleaner base on it!
