DCwom 78 #1 Posted November 21, 2021 So I was draining my trans again today (previous thread about water in trans) and while jacking the front end up with a 4x4, see-saw style (me as counter weight) the fulcrum slipped (or something) and the next thing I know I was rolling on the garage floor. I'm ok and I thought the horse was too, but I found a grease fitting on the floor about midway back. The fitting looks to be broken off, and so I felt around the but didn't find any "holes", I just looked up the raider manual and it looks like there might be a fitting on the front yoke but its not labeled. I suspect this might be where it came from when the front end fell. If this is a fitting, I suspect this is a drill & tap project. Thoughts? DCwom Share this post Link to post Share on other sites
lynnmor 7,852 #2 Posted November 21, 2021 That is a grease fitting. What you need to get out the broken part depends on how much you have sticking out. Share this post Link to post Share on other sites
squonk 43,934 #3 Posted November 21, 2021 Left hand drill bit and a drill in reverse may get it out. 2 Share this post Link to post Share on other sites
Thor27 835 #4 Posted November 21, 2021 (edited) it's hollow, should be able to tap in a small easy out Edited November 23, 2021 by Thor27 can't spell 4 1 Share this post Link to post Share on other sites
