Jump to content
krohs nest

Throttle cable

Recommended Posts

krohs nest

Finishing up my GT-14 rebuild (finally close to the end) what is the best route to run the throttle. Pictures would be great.

Thanks Guys.

Share this post


Link to post
Share on other sites
 
peter lena

KROHS NEST, don,t have any pictures , others will show you those, recommend  you add more cable clamps like these to your set up , https://www.grainger.com/product/KMC-Cable-Clamp-481Y33  only use this for a picture reference , your local h/w store should have them in the small pull out drawer section . thoroughly pre lubricate the cable to verify operation , and add clamps to make it a smooth solid control point , pete

Share this post


Link to post
Share on other sites
 
The Tuul Crib

I'm assuming you were talking about a big block engine. This is the only picture I have of the way I ran mine.

6B00BBFA-0C23-4DA0-A776-38742F973866.jpeg

  • Like 1

Share this post


Link to post
Share on other sites
 
krohs nest
On 4/7/2021 at 1:27 PM, The Tuul Crib said:

I'm assuming you were talking about a big block engine. This is the only picture I have of the way I ran mine.

6B00BBFA-0C23-4DA0-A776-38742F973866.jpeg

 

Share this post


Link to post
Share on other sites
 
krohs nest

You guys are amazing, just what I needed.

Thanks again

Share this post


Link to post
Share on other sites
 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...