How to replace a seal help required

[AliT 13]

Hi there 

 

please can someone let me know if I have to take the transmission apart to change the seal in the attached photo. Thank you Ali

[Jeff-C175 7,195]

While some might know by looking, I don't.

 

What is it?  

 

Can you see the seal from the outside?

[Bill D 1,596]

It is not necessary to take the transmission apart to change that seal.  You should be able to removed it from the input shaft with a small screwdriver.  Check out the pinned thread at the top of the transmission section to find the proper SKF seal number.  Bill

[gwest_ca-(File Mod) 10,488]

The seals are only 1/8" deep so don't drive the screwdriver in too far or you will hit the bearing. I use a scratch awl and since they are so shallow it does not take much to pop them out.

 

Garry

[peter lena 8,038]

while I agree with gwest above , have used packing pullers for years to repack tank drives , https://www.google.com/search?sxsrf=ALeKk02CROtg-JMarTRSshEDBHaHYdytVQ:1617549965845&source=univ&tbm=isch&q=packing+puller&sa=X&ved=2ahUKEwjE_vqY8-TvAhWuGFkFHXt3B5UQjJkEegQIFBAB&biw=1024&bih=625 , drill a tiny hole , screw it in  and pop it out  , pete

[Jeff-C175 7,195]

47 minutes ago, peter lena said:

packing pullers

 

"Honey, have you seen my cork screw?

[The Tuul Crib 7,332]

Use a small ice pic type tool and just be careful not to go too deep with it because there is a needle bearing behind it and it can be damaged. Putting it back on clean the shaft thoroughly put a little masking tape over the keyway and some Vaseline on the seal and shaft. Tap it in gently with a socket that fits over the shaft that is slightly smaller than the seal.

[CCW 1,201]

Thanks for posting this thread.  I have to do the same to my 312.

ccwpost