bottjernat1 2,189 #1 Posted August 4, 2020 I just wanted to share a quick video I did yesterday twice. LOL I learned me some stuff yesterday. Im sure putting the flywheel cover on would be a lot easier if i unbolted the engine. This was my first time doing this task. only issue is i do have one outside flywheel cover bolt snapped i may remove in the future and repair it. For now it works and I wont get debris in the flywheel area. I took her out for a spin when i was done. She still runs like a champ. Only thing Im not fond of is the fuel pump I have to prime the pump every time or spray starting fluid in her. May need to go a different route for the fuel. I hate to tho I like to keep things original. I am using a john deere filter maybe its just to big of a filter. Share this post Link to post Share on other sites
gwest_ca-(File Mod) 10,441 #2 Posted August 4, 2020 Looks like the new bolt into the flywheel on the left side is still loose. . Garry Share this post Link to post Share on other sites
bottjernat1 2,189 #3 Posted August 4, 2020 4 minutes ago, gwest_ca said: Looks like the new bolt into the flywheel on the left side is still loose. . Garry I ended up tightening them down after my video they where all a bit loose. Good eye! Share this post Link to post Share on other sites
bottjernat1 2,189 #4 Posted August 4, 2020 I tell you what this was a chore of a job. LOL Share this post Link to post Share on other sites
pfrederi 17,039 #5 Posted August 4, 2020 Even more fun if you have to move the engine 1 Share this post Link to post Share on other sites