Jump to content
Burnerman

Front spindle size of Commando800?

Recommended Posts

Burnerman

Are the front spindles 3/4” or smaller?

72 Commando 800 with a Kohler. 

Share this post


Link to post
Share on other sites
 
wallfish

3/4

  • Thanks 1

Share this post


Link to post
Share on other sites
 
Burnerman

Thanks!

This tractor thing is starting to get out of hand. D1D19443-0D26-42CE-AEA9-E5918B81AAC8.jpeg.60cb67667d2834e01537c8ffdcba4cf8.jpegAs soon as my son gets home with the trailer this will be the next project. 😁:greetings-clappingyellow:

  • Like 1

Share this post


Link to post
Share on other sites
 
wallfish
2 hours ago, Burnerman said:

This tractor thing is starting to get out of hand. 

There's certainly worse things we could be doing so don't fret over how many it gets up to. You'll find the comfort zone.

  • Like 1
  • Haha 1

Share this post


Link to post
Share on other sites
 
elcamino/wheelhorse

If that is the original deck it has double d spindles and blades. 

Share this post


Link to post
Share on other sites
 
troutbum70

I can measure mine tomorrow and report back.

Share this post


Link to post
Share on other sites
 
Burnerman
6 hours ago, troutbum63 said:

I can measure mine tomorrow and report back.

No need sir! I had another set of rims that I was going to bring with us to make it easier to load onto the trailer but was not required. 
 

 

7 hours ago, elcamino/wheelhorse said:

If that is the original deck it has double d spindles and blades. 

I haven’t gotten the deck off yet but I do believe it’s the original deck.  

Share this post


Link to post
Share on other sites
 
redone

Ok guys. Another issue with onan 20 hp onan performer 20 xls. Starts good. From idel to higher rpm 3000 runs high then drops. Up and down rpm. Raise to higher speed it comes of it, but better. 

Adjusted only jet on side of carb no differance. Is this an easy fix?

Thanks

Bill

Share this post


Link to post
Share on other sites
 
pfrederi
4 minutes ago, redone said:

Ok guys. Another issue with onan 20 hp onan performer 20 xls. Starts good. From idel to higher rpm 3000 runs high then drops. Up and down rpm. Raise to higher speed it comes of it, but better. 

Adjusted only jet on side of carb no differance. Is this an easy fix?

Thanks

Bill

  you may get more help if you make this a new topic as you problem has no relation to the original post

Share this post


Link to post
Share on other sites
 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...