case442 132 #1 Posted March 29, 2009 Hi all, I'm new to the Wheel Horse products. I have recently picked up a 1975 D-180 tractor with the PTO, 3 point hitch, 48" mower deck, blinley plow, rototiller, and a newer (77-79?) parts tractor. Now for my need! the pto hub part #102906 stamped on the hub, is worn out and cracked. I live in the pittsburgh PA area, and cant seem too locate one. I'm sure I could take it to a machine shop and have it repaired, however if anyone has one available, please let me know. My tractor Model number is 1 0612. Thank you, Mike Share this post Link to post Share on other sites
wheel horse 1045 2 #2 Posted March 29, 2009 did you check ebay? Share this post Link to post Share on other sites
case442 132 #3 Posted March 29, 2009 Hi, Yes I looked on E-Bay first but didn't see what I need. Thanks, Mike Share this post Link to post Share on other sites
refracman 167 #4 Posted March 29, 2009 Mike Its possible I have what you need, Look at this and determine which part you need and we can go from there.\ http://www.partstree.com/parts/?lc=toro_co...-39850036-00016 Share this post Link to post Share on other sites
case442 132 #5 Posted March 30, 2009 Hi Steve, Thank you for the info, according to the spec sheet the part # 14-24 or 14-25 is what I need. I would imagine that I need the part that is "not available" as the $ 20 something dollar part seems way too cheap for that assembly. If you do have this part that would be great!. I noticed today I also need the small u-joint in my pto shaft for the tiller perhaps you would know if they are still available. Thanks again Steve! Mike Share this post Link to post Share on other sites
bitten 134 #6 Posted March 30, 2009 Mike #14-24 is the part you are looking for, atleast that is what Im thinking from your post. I almost sure i have one if Steve doesnt. You will need to get the clutch disk # 14-25 and the 4 brass rivets to go with it. When I did mine I got all new bearings, washers, snap rings and the spiroloc rings. Was kinda pricy but I know that it will last for a very long time with the proper care that the previous owner neglected. I actually take it off when Im not useing the tiller to prolong the life of it. My manual says to take it apart once a year and greas it. As for the tiller u-joint Im not to sure of right now. I cant find my manual for it to give you the part number. If you have the model number just put it into the link that Steve gave you and you will be able to see if Toro has it or maybe cross referance it to other u-joints. Hope this helps, P.J. Share this post Link to post Share on other sites
refracman 167 #7 Posted March 30, 2009 Mike Don't have the u joint but I believe have the clutch part. I'll check tomorrow nite and send you a pm. Share this post Link to post Share on other sites
case442 132 #8 Posted March 30, 2009 Steve and PJ, Thank you so much guy's, I really appreciate your help in this matter. Let me know how much you would like for the parts if by chance you do have them. Iwould like to get my tiller going. By the way the Brinly single bottom plow, does this tractor have enough power to pull this? it looks really big!. Thanks again, Mike Share this post Link to post Share on other sites
catman81056 3 #9 Posted March 30, 2009 By the way the Brinly single bottom plow, does this tractor have enough power to pull this? it looks really big!. Power to spare :omg: Share this post Link to post Share on other sites
