Jump to content
rj24

C-105 mod with a Onan BF engine PTO problem

Recommended Posts

rj24

Hello guys I have a problume that just came up I'm a 1/4" short on the shaft will that hart anything or do I need to find a way to fix it 

52426953_2135655846455287_1757191723475271680_o.jpg

Share this post


Link to post
Share on other sites
 
Lee1977

If the crank shaft is drilled and tapped you can bolt on as much additional shaft as you need. I was running 16 Briggs Vanguard with a short shaft and added an inch or so. Ran 20 years like that.

  • Like 1

Share this post


Link to post
Share on other sites
 
peter lena

check out the , INNER PULLEY ON THE SHAFT , had a similar issue on a recent engine / pto. backed off the two Allen screws  on the inner pulley shoulder then carefully tap at inner base of pulley, lubricate area, if that shoulders out and gives you what you need , that's what happened to me. this was a used engine , but the gap you have between side of block and inside of pulley, looks what I had. good luck , pete

Share this post


Link to post
Share on other sites
 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...