improving snow blower, spring assist

[peter lena 9,302]

https://www.galco.com/buy/Crouse-Hinds/RAC50HD?source=googleshopping&gclid=EAIaIQobChMIkfuG2Zf33gIVh7rACh2TuwtlEAQYBCABEgKsevD_BwE   this is the clamp I use to secure and back up the post clamp on the spring assist for blower . picture shows its mounting, and its rear strike area. makes it simple and strong, pete

[formariz 12,045]

Can you show a photo of it installed?

[peter lena 9,302]

sure, how about this ?  note the carouse and hinds clamp is behind the spring mount, you will tap on the flat horizontal in back to drive both forward ,and increase tension . slightly loosen both clamps . if you don't like this spring mount, you could use a  " riser clamp " for vertical piping, about 1- 1/4"  , cut off the side excess and replace the bolts with 3/8" eye bolts to secure springs . I have tried both, pete