Cetan08 311 #1 Posted August 8, 2018 Wanting to keep my D-160 as original as possible, I got a k-341 Kohler from the Diesel Doctor and removed the Onan. I now have a running and fully functional D-160. I did need to fabricate some temporary engine mounts as they were missing when I purchased the tractor. I have a wanted add posted but don't have hopes of finding one. Does anyone have the dimensions of the plate that I need so that I can make one. I figure that it is a thick piece of steal. I have searched everywhere and have pictures of it in the parts manual but that is it. Thanks everyone Share this post Link to post Share on other sites
19richie66 17,655 #2 Posted August 8, 2018 I have one sitting on my bench. About 1” thick steel plate with holes for frame and motor. Came out if a 1974 D-160 1 Share this post Link to post Share on other sites
Cetan08 311 #3 Posted August 8, 2018 That is the year of my D-160. Are you using it? If you would part with it, How much. Share this post Link to post Share on other sites
19richie66 17,655 #4 Posted August 8, 2018 (edited) Just laying there. Was going to make an engine run stand and use it as a base. Haven’t done it in 4 years. 😂 Sent you a pm. Edited August 8, 2018 by 19richie66 1 Share this post Link to post Share on other sites
