liammc999 0 #1 Posted July 14, 2018 Hello I am new to this forum. I am after acquiring a 110-4 lawn mower from a neighbour in a few pieces. All the pulleys are in a bag and I have them all as I have matched them with the manual. I cannot figure out where the pulleys go. I cant make head nor tail of the manual with regards the pulleys Any advice or even better pictures would be a huge help! Thnks Liam Ireland Share this post Link to post Share on other sites
The Tuul Crib 7,339 #2 Posted July 14, 2018 (edited) Welcome to Red Square and I might say you'll not find a nicer bunch of folks that are very helpful and what you might need. I don't have the configuration you need but somebody will have it I'm sure good luck with your project 👍 Edited July 14, 2018 by The Tool Crib Share this post Link to post Share on other sites
daveoman1966 3,841 #3 Posted July 14, 2018 The schematics are in file at this web site: http://www.psep1.biz/arinet.asp?aribrand=TO# Just enter your model # as 110-4 ...the years appear to be all the same. Share this post Link to post Share on other sites
