Chris689 158 #25676 Posted yesterday at 01:26 AM On 4/6/2026 at 5:14 PM, ebinmaine said: Niiiiice work! Thank you. I’ve been looking for a front hitch for a couple years now. I found a few on eBay a while ago but haven’t seen em on there since. I ran across the thread on here a few days ago and remembered I got a seized up mule drive with my 73 and figured it was the perfect candidate. 1 1 Share this post Link to post Share on other sites
BrianKoch 367 #25677 Posted 7 hours ago (edited) On 4/5/2026 at 10:23 AM, BrianKoch said: Happy Easter Gentlemen! This morning I began the process of figuring out what is leaking on the 312A’s hydro pump. Lot of cleaning ahead of me… I also ordered a new motion control plate as this one is pretty wallowed out. Update: I refilled the reservoir with SAE 30 motor oil and waited and waited and waited. Then, I noticed oil weeping out from under the cam follower arm. After looking at the parts diagram, it doesn’t appear there is a serviceable seal underneath. Anyone have more experience with this issue? Also, in preparation for the upcoming replacement cam plate operation, I removed the 106661 eccentric cam and sure enough it needs replacing due to excessive wear. Grass is growing day by day. Gotta get this horse out to pasture soon! Edited 7 hours ago by BrianKoch Share this post Link to post Share on other sites
CasaytheMann 3 #25678 Posted 6 hours ago I changed the oil and oil filter, and greased all 4 zircs. The recycler deflector had both bottom corners broken off, which sent grass all over the place, so I installed a piece of flooring and metal retainer to block it off. Buying a new deflector and parts for $75+ isn't in my budget at the moment. On a side note, I went down to the local Autozone to buy some sae30 oil. I didn't see any on the shelf so I asked an employee if they had any in the back warehouse. I told him I needed 2 qts. He came back with 2. When they rung it up, it showed it was 1 cent a qt. The manager said it was discontinued and they just wanted to get rid of it. I told them I'd buy whatever they had left. Walked out with 7 qts for 8 cents (sales tax was 1 cent). 1 1 Share this post Link to post Share on other sites
cleat 8,860 #25679 Posted 4 hours ago 3 hours ago, BrianKoch said: Update: I refilled the reservoir with SAE 30 motor oil and waited and waited and waited. Then, I noticed oil weeping out from under the cam follower arm. After looking at the parts diagram, it doesn’t appear there is a serviceable seal underneath. Anyone have more experience with this issue? Also, in preparation for the upcoming replacement cam plate operation, I removed the 106661 eccentric cam and sure enough it needs replacing due to excessive wear. Grass is growing day by day. Gotta get this horse out to pasture soon! Here is the parts diagram for an Eaton 1100. I think the control shaft and seal should be the same on your Eaton 700 Hydro.pdf For some reason they pictured it upside down. The control shaft is #37 and your seal is #36 1 Share this post Link to post Share on other sites
