Rayp 15 #1 Posted June 16, 2016 Can anyone please help with the lift linkage, i.e. which holes in the Lift Arm and Bell End the lift rod should be fitted and can anyone supply or direct me to a supplier of bushes (which appear to be made of tin and which fit into the Chassis at the ends of moving rods. Itried to load some photos but don't think it has worked! Share this post Link to post Share on other sites
cleat 7,260 #3 Posted June 16, 2016 Are your bushings worn ? I have never seen a worn one in all the machines I have torn down. Share this post Link to post Share on other sites
Rayp 15 #4 Posted June 16, 2016 Don thank you very much for the illustration which is very clear and helpful. Cleat - for some reason 2 of the bushings were absent when I dismantled my tractor and I don't know if those that are present are genuine ones as they only appear to be pressed tin. Share this post Link to post Share on other sites
Phatboy 565 #5 Posted June 16, 2016 (edited) You can get those bushings from "wheelhorseman1000.com" ,,, a vender and a member here and a great guy,,, always available for phone support also,, those bushings are supposed to be made out of bronze not tin,, they are about 5 bucks for the pair, and he will have them at your door in approx 2 days..just tell him i sent ya ! Edited June 16, 2016 by Phatboy 1 Share this post Link to post Share on other sites
squonk 43,845 #6 Posted June 17, 2016 (edited) Which bushings in the pic are in question? If it's # 28 I've seen these worn out a lot. Edited June 17, 2016 by squonk Share this post Link to post Share on other sites
Rayp 15 #7 Posted June 17, 2016 Yes, it is bushing 28 Mike. Thanks Phatboy for the details of Wheelhorseman. I have looked at the website and its a great source of parts. Share this post Link to post Share on other sites
