Levi 2 #1 Posted June 16, 2016 Hey fellas, I'm building a wheel horse raider 10 with a Yamaha 400 twin motorcycle engine in it and I was wondering if the transmission can hold that kind of torque. Any thoughts? Share this post Link to post Share on other sites
russellmc301 600 #2 Posted June 16, 2016 im sure a uni- drive could, many use them in pulling tractors. Share this post Link to post Share on other sites
Levi 2 #3 Posted June 16, 2016 8 minutes ago, russellmc301 said: im sure a uni- drive could, many use them in pulling tractors. I'm not exactly sure the model tranny, but it's the 3+R and H/L. Does it have ball bearings inside or just a copper sleave? Share this post Link to post Share on other sites
C-101plowerpower 1,606 #4 Posted June 16, 2016 8 hours ago, Levi said: I'm not exactly sure the model tranny, but it's the 3+R and H/L. Does it have ball bearings inside or just a copper sleave? usually ball bearings for the diff, a few used rollerbearings for the diff. rest of the bearings are needle bearings if i'm correct. what size rear axles does it have? 1" or 1 1/8 " ? Share this post Link to post Share on other sites
gwest_ca-(File Mod) 11,499 #5 Posted June 16, 2016 1-1/8" axle is likely transmission model 5073 in 1970-71 1" axle is likely transmission model 5086 in 1972 Items 53 and 54 are bronze bushings. Garry Share this post Link to post Share on other sites
Levi 2 #6 Posted June 16, 2016 12 hours ago, Levi said: Ok thanks guys. I plan on going down the road with it at fairly high speeds and I wasn't sure about the torque or speed capabilities. I had pics on my phone of the build, but I lost them so I will have to get some more later. Share this post Link to post Share on other sites
