buffaloman 295 #1 Posted May 8, 2016 ok so I pulled the carb off the 702 and cleaned it all up put it back together im assuming correctly,but now once it runs for a few seconds theres all kinds of gas coming out the air intake hole. now I should mention,that my o-ring gasket on the bowl expanded and was too big to fit so I did splice it but that I wouldn't think would cause any issues ? any ideas? Share this post Link to post Share on other sites
buffaloman 295 #2 Posted May 8, 2016 ok so I pulled the carb off the 702 and cleaned it all up put it back together im assuming correctly,but now once it runs for a few seconds theres all kinds of gas coming out the air intake hole. now I should mention,that my o-ring gasket on the bowl expanded and was too big to fit so I did splice it but that I wouldn't think would cause any issues ? any ideas? Share this post Link to post Share on other sites
AMC RULES 37,196 #3 Posted May 8, 2016 Sound like you need a new carb kit... and complete the process again. 3 Share this post Link to post Share on other sites
squonk 43,908 #4 Posted May 8, 2016 You need a carb kit. New gaskets with a new needle and seat. About $15.00 and an easy repair. 2 Share this post Link to post Share on other sites
prondzy 3,889 #5 Posted May 10, 2016 And this time don't cut the bowl gasket 2 Share this post Link to post Share on other sites
