zanepetty 117 #1 Posted January 7, 2015 I used a small amount of sealer that is rated for gas on my carb mounting gasket. Is that a no no? Share this post Link to post Share on other sites
KC9KAS 4,744 #2 Posted January 7, 2015 I wouldn't say a "no-no", but it will be a real female dog in heat to remove! 3 Share this post Link to post Share on other sites
Mr. 856 170 #3 Posted January 8, 2015 shouldn't hurt but isn't necessary. I have only ever used a sealer on gaskets when a case is split open. Mostly on two strokes though. Share this post Link to post Share on other sites
zanepetty 117 #4 Posted January 8, 2015 Ohkay. I just didn't want it to mess anything up. I couldn't get my fuel pump to stop leaking until I used the sealer so I put it on everything this go around. Share this post Link to post Share on other sites
clem 28 #5 Posted January 8, 2015 I have had success with a thin film of grease, much easier to disassemble also. 1 Share this post Link to post Share on other sites
zanepetty 117 #7 Posted January 8, 2015 Ah man. Why couldn't I have thought of that! Share this post Link to post Share on other sites
