slammer302 2,154 #1 Posted November 14, 2014 So I decided to move up to a 42" deck I've been using a 36" RD the only 42" decks I have was one with the middle spindle rotted out and almost falling off and the other the middle spindle was shot and the pulley was messed up this is the one I'm working on I got the middle spindle off today I will keep you guys updated on my progress and my final product 1 Share this post Link to post Share on other sites
Geno 1,928 #2 Posted November 14, 2014 Faster mowing means more Horse fixing time, or you could mow slower and still get the same seat time. Share this post Link to post Share on other sites
slammer302 2,154 #3 Posted November 14, 2014 Its more of a winter project than a need 1 Share this post Link to post Share on other sites
slammer302 2,154 #4 Posted November 14, 2014 In the working deck section at my house i have three 48" seven 36" RD but no 42" Share this post Link to post Share on other sites
slammer302 2,154 #5 Posted November 14, 2014 I got what was left of the key out of the pulley I hope the hole isn't worn out to much Share this post Link to post Share on other sites
slammer302 2,154 #6 Posted November 16, 2014 Here's what I ended up with its not pretty but it will be ready for sum grass come summer 1 Share this post Link to post Share on other sites
slammer302 2,154 #7 Posted November 16, 2014 Here's a pic of the deck I used for parts Share this post Link to post Share on other sites
boovuc 1,090 #8 Posted November 16, 2014 Did someone check out their full choke on a 12 gauge in the middle of your parts deck? Share this post Link to post Share on other sites
Geno 1,928 #9 Posted November 16, 2014 It will be pretty when you get done with it Slammer. Share this post Link to post Share on other sites
slammer302 2,154 #10 Posted November 16, 2014 I just got done taking one of the spindles apart wanted to make sure the bearings are good Share this post Link to post Share on other sites
slammer302 2,154 #11 Posted November 17, 2014 I got the bottom wire wheeled and the baffles welded up I not sure if I should just paint it or put ez slide on it I have a little bit left from the last deck I cleaned up what do you guys think 1 Share this post Link to post Share on other sites
bowtieguy 334 #12 Posted November 18, 2014 POR it~~~!!!....smalll can from Eastwood will do about 2 decks.....good stuff but don't inhale it~~ Share this post Link to post Share on other sites
slammer302 2,154 #13 Posted November 18, 2014 I will have to give it a try Share this post Link to post Share on other sites
Geno 1,928 #14 Posted November 18, 2014 Looking good Slammer. Share this post Link to post Share on other sites
slammer302 2,154 #15 Posted November 19, 2014 Here's the final results Do you guys think this will be to much deck for my B-60 Share this post Link to post Share on other sites