mark033 0 #1 Posted October 23, 2014 need the idler pully that the drive belt rides on from the crank to the cooling fan for the trans. tried too order one from the dealer says its discontinued ADVISE PLEASE TKS Share this post Link to post Share on other sites
Desko 552 #3 Posted October 24, 2014 need the idler pully that the drive belt rides on from the crank to the cooling fan for the trans. tried too order one from the dealer says its discontinued ADVISE PLEASE TKS Its not discontinued but it is $75 new need 1 for my 416 and priced it and was shocked but don't worry Dennis will take care of you and get you a good one Share this post Link to post Share on other sites
gwest_ca-(File Mod) 10,499 #4 Posted October 24, 2014 Post the dimensions and will look in my lists to see if there is a more reasonable replacement. Garry Share this post Link to post Share on other sites
Desko 552 #5 Posted October 24, 2014 If your asking me I don't have it out but it is squealing and getting hot so its only a matter of time before it lets go. Share this post Link to post Share on other sites
mark033 0 #6 Posted October 24, 2014 (edited) bold whole .377 dia....... sleeve length 1.175....... 4 inch dia were belt rides,,,,, back side of belt rides on pully ,,,,,,, pully .875 wide Edited October 24, 2014 by mark033 Share this post Link to post Share on other sites
gwest_ca-(File Mod) 10,499 #7 Posted October 24, 2014 Try these part numbers here at this Stens dealer in Canada http://www.bantasaw.com/ 280-826 (Napa 7-05207) 280-123 280-495 (Napa 7-05211) This last one is riveted together in the Stens illustration and they usually have a real good ball bearing in them. Let us know what you come up with so it helps others. Garry Share this post Link to post Share on other sites
ericj 1,576 #8 Posted October 25, 2014 i haven't tried it , but was told to take a 48" deck idler pulley and punch the spacer or bushing out of the old pulley and reuse. like i've said have never tried, but was told this by a dealer as a substitute for the 520 idler pulley eric j Share this post Link to post Share on other sites
flyovrcntry 115 #9 Posted October 25, 2014 I know he says barring,but it works,I have done it 1 Share this post Link to post Share on other sites